Bearing Protectors 45mm 2pk AL-KO

Description

A Bearing Protector not only automatically lubricates your bearing but also protects your bearing from water and dust ingress.
Suits hubs with a 45mm diameter bearing housing including Holden, Ford & Composite bearings.
Bearing Protectors are also known as Bearing Buddies.

Installation instructions
1. Clean and remove any burrs from hub bore.
2. Pack the hub bore and the Bearing Protector with grease before initial installation.
3. Place a small block of timber over the Bearing Protector, tap on the timber with a hammer until Bearing Protector is firmly seated in front hub bore.
4. Fill the Bearing Protector with grease through the nipple until piston is pushed about halfway to its limit.

Caution: Do not over grease or the Bearing Protector will be forced out and the grease will escape through the rear of the hub.